Eco RGB Guide

Press and hold LED button to wake saber from sleep mode. A 'power on' audio clip will play to confirm that the saber is awake. To activate saber, press the activation button again.

The following table provides a list of commands you can activate using the saber. Eco sabers with lit activation switches will flash every second while held. However, most of our Eco sabers made by LGT do not have an illuminated activation switch. To help with this issue, we've provided hold timings along with LED flashes.

While Blade is active:

 Control Effect Additional Info
Press Button Blaster Deflect
Hold for 1 LED Flash / 1 Second Lock-up Press button once to end lock-up
Hold for 2 LED Flashes / 2 Second Activate color change As colors change, press button again to lock color
Hold for 3 LED Flashes / 3 Seconds Activate quick color change As colors change, press button again to lock color
Hold for 4 LED Flashes / 4 Seconds Deactivate saber blade Saber will return to wake state

While blade is not active (wake mode):

 Control Effect Additional Info
Press Button Activate Saber
Hold for 1 LED Flash / 1 Second Volume Adjust Can be set to high, low, and mute
Hold for 2 LED Flashes / 2 Second Light Effect Can be set to Stable, Unstable, and Pulse
Hold for 3 LED Flashes / 3 Seconds Motion Control Toggle Enable or disable motion controls. Does not change font selection on twist
Hold for 4 LED Flashes / 4 Seconds Flash-on-clash Toggle Enables or disables impact effect
Hold for 5 LED Flashes / 5 Seconds Font Change Select the next soundfont
Quick Saber Twist (key turn motion) Font Change Alternate method to select the next soundfont
Hold for 10 seconds Sleep Mode Saber will sleep automatically if idle for 10 minutes