Blade Installation

To Install your saber blade, first locate your provided Hex key. This can be found inside of a bag located in your shipping box. Next, locate the retention screw nearest to the emitter. Most sabers will have two retention screws near the top of the saber.

Loosen the top retention screw to release the blade plug protecting your LED from dust. Once removed, you can install the blade.


Note: Do not loosen the 2nd lower screw. That secures the LED module and prevents it from releasing which can cause wire damage.


Next, take your blade and insert it into the top of the saber until it stops. Note: if your blade will not go down all of the way, make sure the retention screw is not obstructing the blade.

Use the Hex key wrench to secure the blade by tightening it into blade, turing it right until firmly

secure.


Note: Do not overtighten blades. This can cause stripping which will require repair at our facility. Tighten the screw gradually. You can test how secure the blade is by lightly pulling it once the screw stops turning.


Battery Charging


Warrior Sabers (without in-hilt recharge)

To charge your battery first make sure the saber is powered down (latching switch in off position). Remove the pommel by rotating it counter clockwise until it separates from the saber.

Inside the saber, locate the plastic tab and carefully pull the battery chassis out from the saber. Note: Pulling too hard can cause wires to be damaged during this step


Remove battery by pushing the battery out from the back and place battery in provided charger.

When battery is inserted correctly, an LED will light up to indicate that it is charging. When charging is complete, the LED will turn green.

Charging can take between 6-12 hours. We recommend charging batteries overnight or purchasing an additional battery


In-Hilt Recharge

Warrior / Veteran / Hero

Simply plug the charger into the saber charge port by removing the kill key located below the activation switch. Do not try to remove the battery via the pommel as it is secured internally to the soundboard and chassis.

Champion

Champion tier sabers can be charged using the micro USB port and USB cable packaged with the saber. A blinking light will signal that the saber is charging.

NOTE: Warrior sabers with in-hilt recharge exclusively retain access to the battery via the pommel. This means you can have backup batteries and switch batteries at any time.

Have more questions or need assistance?

Get help from our customer service staff. Write us a detailed e-mail and we'll respond as soon as possible

Contact Us

Ways to get in touch with us

Product Info and Online Orders

sales@saberforge.com

10am to 6pm (PST) M-F

Showroom/Local Orders

showroom@saberforge.com

12pm to 8pm (PST) M-Su

Visit Us

Showroom & Headquarters

270 Beavercreek Rd STE 200

Oregon City OR 97045