Eco Sabers

Last Updated: November 21 2019

Blade Installation

Opening retention screw & removing blade plug

To Install your saber blade, first locate your provided Hex key. This can be found inside of a bag located in your shipping box. Next, locate the retention screw nearest to the emitter. Most sabers will have two retention screws near the top of the saber.

Loosen the top retention screw to release the blade plug protecting your LED from dust. Once removed, you can install the blade.

Note: Do not loosen the 2nd lower screw. That secures the LED module and prevents it from releasing which can cause wire damage.

Blade Installation

Next, take your blade and insert it into the top of the saber until it stops. Note: if your blade will not go down all of the way, make sure the retention screw is not obstructing the blade.

Use the Hex key wrench to secure the blade by tightening it into blade, turning it right until firmly secure.

Note: Do not over tighten blades. This can cause stripping which will require repair at our facility. Tighten the screw gradually. You can test how secure the blade is by lightly pulling it once the screw stops turning.

Activation

Eco Sabers come moderately charged and in deep sleep. To bring the saber out of deep sleep mode, hold the activation switch for 6 seconds and an audio cue will play. When out of deep sleep, the power LED will light up. To ignite/activate blade, press activation switch. 

Blade Lock-Up FX

While blade is active, hold the activation switch for 2 seconds, release, then tap again. Tap switch again to deactivate effect.

Deactivation

Holding the activation switch down for 4 seconds will deactivate the saber. After a few minutes of inactivity, Eco Sabers will play an audio cue and enter deep sleep mode. Activation LED will also turn off.

Mute Audio/Force Deep Sleep

Holding the activation button down while the switch LED is still active will force your saber into deep sleep mode.This will also switch the saber into muted mode the next time you turn it on. Reverse this process to enable sound.

Charging

Simply plug the charger into the saber charge port located above the activation switch. Do not try to remove the battery via the pommel as it is secured internally to the soundboard and chassis.

Have more questions or need assistance?

Get help from our customer service staff. Write us a detailed e-mail and we'll respond as soon as possible

Contact Us

Ways to get in touch with us

Product Info and Online Orders

sales@saberforge.com

9am to 6pm (PST) Tuesday - Friday

Showroom/Local Orders

showroom@saberforge.com

12pm to 8pm (PST) Monday - Sunday

Visit Us

Showroom & Headquarters

270 Beavercreek Rd STE 200

Oregon City OR 97045