Champion Tier sabers
Last Updated: 11/21/2019
Opening retention screw & removing blade plug
To Install your saber blade, first locate your provided Hex key. This can be found inside of a bag located in your shipping box. Next, locate the retention screw nearest to the emitter. Most sabers will have two retention screws near the top of the saber.
Loosen the top retention screw to release the blade plug protecting your LED from dust. Once removed, you can install the blade.
Note: The following sabers (and variations) do not include a blade plug: Chosen, Talon, Forsaken, Exalted, Descendant, Adept, Redeemer, Prodigal Son, Shadow Hunter, and Marauder.
Note: Do not loosen the 2nd lower screw. That secures the LED module and prevents it from releasing which can cause wire damage.
Blade Installation & Tightening
Next, take your blade and insert it into the top of the saber until it stops. Note: if your blade will not go down all of the way, make sure the retention screw is not obstructing the blade.
Use the Hex key wrench to secure the blade by tightening it into blade, turning it right until firmly secure.
Note: Do not over tighten blades. This can cause stripping which will require repair at our facility. Tighten the screw gradually. You can test how secure the blade is by lightly pulling it once the screw stops turning.
Tap (quick press) the switch to wake up the saber. Quick press the switch again to activate the saber. To power down, simply hold the power led (long press) until the saber turns off.
Note: Champion sabers will go into deep sleep and the power LED will turn off automatically after 5 minutes of inactivity.
While saber is on (blade active) tap the power button to activate the blaster deflect sound effect.
To activate blade lock-up effect, hold the power button for 2 seconds, release and tap the button again. To deactivate the effect, tap the power button.
Hold the power button for 2 seconds (until audio cue plays) to enter soundfont selection. To cycle through fonts, tap the power button. To select the current font, hold the power button until a “locked-in” audio cue plays. Then tap the power button to power to activate.
Champion tier sabers can be charged using the micro USB port and USB cable packaged with the saber. A blinking light will signal that the saber is charging. Sabers require 4 - 6 hours for a full charge.
To edit the soundfonts, volume, blade effects, and other options, Champion sabers feature an editor that allows you to further customize your saber.
Saber is shutting down during clash or blaster deflect
This is usually an indication of a low battery. Charge your saber and the issues should go away.
Saber is not charging or connecting to a windows 10 computer
If you’re experiencing this issue, try a different micro USB cable. Make sure there is no debris or dust in the USB port/cable that could prevent the contacts from making a clean connection.
I’m installing a 3rd party sound font.
When using 3rd party sound fonts, the font must have a “startup.wav” file or it will not work.
Note: While our champion sabers are compatible with 3rd party sound fonts, we do not provide customer assistance with installation and troubleshooting. Saberforge is not responsible for issues that may result from using 3rd party software.
Have more questions or need assistance?
Get help from our customer service staff. Write us a detailed e-mail and we'll respond as soon as possibleContact Us