LGT/Eco Xenopixel Guide

Update v1.8 - 11/14/22


1. Remove battery from core
2. Remove SD card from core
3. Place SD card in SD card reader
4. Connect SD card reader to computer
5. Copy files from SD card and save to desktop
6. Delete “set” folder from SD card
7. Unzip firmware update folder and locate new “set” folder
8. Place new “set” folder onto SD card
9. Replace SD card into core
10. Replace battery into core
11. Listen for firmware update confirmation sound


Press and hold LED button to wake saber from sleep mode. A 'power on' audio clip will play to confirm that the saber is awake. To activate saber, press the activation button again.

The following table provides a list of commands you can activate using the saber. LGT sabers with lit activation switches will flash every second while held. However, most of the LGT sabers we carry do not have an illuminated activation switch. To help with this issue, we've provided hold timings along with LED flashes.

While Blade is active:

 Control Effect Additional Info
Press Button Blaster Deflect
Hold for 1 LED Flash / 1 Second Melt/Tip Drag Press button again to end effect. (Effect only visible on 37 inch blades)
Hold for and clash Blade Lock-Up Effect persists while button is held
Hold for 2 LED Flashes / 2 Seconds Activate color change As colors change, press button again to lock color
Hold for 4 LED Flashes / 4 Seconds Deactivate saber blade Saber will return to wake state

While blade is not active (wake mode):

 Control Effect Additional Info
Press Button Activate Saber
Hold for 1 LED Flash / 1 Second Volume Adjust Can be set to high, low, and mute
Hold for 2 LED Flashes / 2 Second Blade Effect Can be set to: Steady, Pulse, Rainbow, Unstable, and Fire
Hold for 3 LED Flashes / 3 Seconds Blade Mode Can be set to: Standard, Blaster, Ghost, Broken, Stack, Photon, Warp, Phaser, Scavenger, Hunter,
Hold for 4 LED Flashes / 4 Seconds Font Change Select the next soundfont
Hold for 10 seconds Sleep Mode Saber will sleep automatically if idle for 10 minutes